10
Loading Paper
Note:
• Printer appearance may differ because of various models and functions, so the schematic
diagram is only for your reference.
Load in the standard feed tray
:To avoid the risk of electrical shock, if you are accessing the controller board or memory
devices after setting up the printer, turn the printer o
ff
, and unplug the power cord from the
electrical outlet before continuing. If you have any other devices attached to the printer, turn them
o
ff
as well, and unplug any cables going into the printer.
:To reduce the risk of equipment instability, load each tray separately. Keep all other trays
closed until needed.
1. Remove the standard feed tray from the printer completely.
Note:
• To avoid paper jams, do not remove the tray while the printer is busy.
Содержание PT14C1A Series
