
Page 1/4
Instructions for assembly
Brake, onehand right
We have developed a new single hand brake available in three width alternatives.
These three brake alternatives fit all our adult chairs, S2, S2 Short (if you don´t have a
shorter seat depth than 35cm) and U2. (Also fits our old standard chair no longer in
production).
Description
Art.no
Suitable for
Brake onehand, new 30-33 right
367 30 33
Chair widths 30 and 33
Brake onehand, new 36-39 right
367 36 39
Chair widths 36 and 39
Brake onehand, new 42-45 right
367 42 45
Chair widths 42 and 45
The brake has to be prepared before being assembled onto the chair. It should be
adjusted according to the model of chair it will be attached to. Since each brake fits
two different widths of chair, this should also be adjusted before assembly.
How to prepare your single hand brake:
1.
Start by checking the width of the chair on which the brake will be assembled.
2.
Adjust the correct width on the brake. On the middle rod there are two holes for
adjusting the width of the brake.
See figure 1
. Loosen the nut and adjust to the desired
width. On the brake 30-33, the inner hole is for width 30. On brake 36-39 the inner hole
is for width 36, and so on.
Panthera Production AB
Gunnebogatan 26, 163 53 Spånga, Sweden
Tel: +46 (8) 761 50 40 Fax: +46 (8) 621 08 10
[email protected] www.panthera.se
Please turn over!
panthera
panthera
Monteringsanvisning enhandsbroms eng - 2005-06-13 Artikelnummer 882 11 27
Adjust the brake width here.
Figure 1