20
Figure 7 – Mounting Bracket and Mounting Bracket Hardware Kit
Radio Mounting Procedures
The following procedures are used to mount the radio.
1.
Using the bracket as a template, mark and drill the mounting holes
using a No. 31 (1/8) drill bit. Be sure to leave enough room at the rear
of the radio unit for the cable connections and airflow.
C AU TIO N
Be careful to avoid damaging some vital part (fuel tank,
transmission housing, etc.) of the vehicle when drilling
mounting holes. Always check to see how far the
mounting screws will extend below the mounting surface
before installing.
If pilot holes must be drilled, remove all metal shavings
from drilling holes before installing screws.
2.
Mount the bracket using the four 3/4” Phillips sheet metal screws and
spacers provided in the mounting bracket hardware kit. (Refer to
Figure 8.)
