7
Bridge installation and configuration guide
January 2018
© 2018 Centrica plc. Registered office: Millstream, Maidenhead Road, Windsor, Berkshire. SL4 5GD.
Registered in England & Wales No 3033654
Mounting the Bridge
You can install the bridge on a flat horizontal surface, mount it on a wall using screws or the re-closeable fastener, or
mount it on a DIN rail.
How to Proceed
1.
Configure the bridge as explained in this guide.
2.
Position the bridge at a distance as follows:
•
Up to 2 meters from the electrical panel, if the panel is covered with a metallic cover.
•
Up to 5 meters, if the panel is not covered.
3.
Choose a clean and even surface, located near a power source.
4.
Make sure the bridge side vents are not blocked.
5.
Attaching with screws: Use the template on the back of the bridge to measure the distance between the
two screws.
6.
Adhering to the wall: Peel the adhesive backing off two pieces of the re-closeable fastener and attach
them to the back of the bridge.
In the same way, attach the two remaining pieces of the re-closeable fastener to the wall, making sure
they are aligned with the pieces on the bridge.
7.
Attaching to a DIN rail: Attach the included DIN rail adapter to the bridge using the two screws
provided. The adapter clips on to a standard DIN rail.
Connecting the Bridge
Depending on the required network configuration, you can connect the bridge to the Internet using Wi-Fi, a cellular
network, or wired LAN.
