BA_PH_690-200_EN_11-22.docx
55
20
Optional Components
20.1
Tele-Digit Cross-Cut Fence
Figure 60: Tele-Digit cross-cut fence
The Tele-Digit is an optional cross-cut fence for PANHANS sliding table saws, which is used instead of the
standard cross-cut fence. A separate measuring system is integrated for each of the two flip stops. This allows
two separate settings of both flip stops. The stop positions are visualised via a wireless digital display. Dust-
insensitive magnetic measuring systems with non-contact scanning are used to determine the position.
20.1.1
Features
•
Two non-contact, dust-insensitive magnetic measuring systems
for separate position measurement for each flip stop
•
Wireless digital indicator (0.1 mm) with battery operation
•
Cutting lengths up to 3000 mm possible
20.1.2
Installation
Figure 61: Fixing points on the cross slide
The Tele-Digit unit is fixed for 90° cuts completely without tools via
the fixing points (
F
) of the cross slide at the desired position (left or
right on the cross slide).
For angle and mitre cuts in combination with the optional mitre
fences Super Gehrfix I or II, the Tele-Digit cross-cut fence is fixed in
the center of the cross slide. For more information on the Super
Gehrfix I and II, refer to the operating manual of your machine.
F
