BA_PH_690-200_EN_11-22.docx
54
19.2
Insert Main Saw Blade
•
Clean flange and saw blade.
•
Insert the new saw blade and mount the flange (
observe the direction of rotation!
)
•
Screw in the clamping screw by hand as far as it will go (
left-hand thread!
).
•
Tighten the grub screw of the clamping screw with a torque of 12 Nm.
•
Close sawdust flap again.
19.3
Riving Knife Setting
The correct adjustment of the riving knife is of great importance for safety. The gap between the riving knife
and the saw blade must be between 3 and 8 mm.
If the riving knife is missing or incorrectly adjusted, there is an increased risk of injury!
Please also observe the hazard warnings in the section
Figure 59: Riving knife setting (symbolic representation)
1.
Loosen the clamping screw on the riving knife holder
2.
Push the riving knife to the desired position
3.
Tighten the clamping screw to fix the riving knife in place
The riving knife is adjusted in height by sliding it in its slot. The gap to the saw blade is adjusted by moving the
entire holder on the rail.
The riving knife supplied with the machine is suitable for saw blades with diameters of 250 - 450 mm.
The diameters indicated correspond to the permissible diameter of the carbide saw blades.
mm
Clamping
screw
