BA_PH_680-200_EN_11-22.docx
39
10.5.3
Usage of further flip stops
The sliding table saw is equipped with a
total of 3 flip stops:
1.
Front flip stop (
Y
) for lengths
up to 1900 mm
2.
Middle flip stop (
M
) for lengths
between 1900 and 2100 mm
3.
Rear flip stop (
Z
) for lengths
between 2100 and 3500 mm
Figure 32: Available flip stops
10.5.4
Extendable fence guide
The extendable fence guide (
I
) is used to guide workpieces for cutting lengths up to 350 cm. It is equipped with
the following functions:
4.
Fixing wheel (
V
) for fixing the extend-
able fence guide (
I
) to the cross slide.
5.
Adjustment wheel (
J
) for the extend-
able fence guide (
I
).
6.
Adjustment screw (
E
) for the rear
flip stop (
Y
).
If the fence guide is pulled out
too far, it can fall to the floor
and cause a crushing hazard.
Figure 33: Extendable fence guide
10.5.5
Reading the cutting length
The cutting length is displayed on three
measuring scales:
1.
Middle ruler (
1
) for cutting lengths
from 2100 cm to 3500 mm.
2.
Front ruler (
2
) for cutting lengths
up to 2100 mm - reading position at
the front.
3.
Rear ruler (
3
) for cutting lengths
up to 2100 mm - reading position at
the back.
Figure 34: Measuring scales on the fence guide
Y
M
Z
I
V
E
J
2
3
1
