PANHANS 680 100, Руководство по эксплуатации, Страница: 51 / 70

BA_PH_680-100_EN_08-22.docx
51
15 Optional Components
15.1 Digital Cross-Cut Fence
Figure 59: Digital cross-cut fence
The optional digital cross-cut fence has three stop ele-
ments, each equipped with its own battery-powered
digital indicator.
The corresponding flip stop is clamped using the hand-
wheel next to the digital indicator (see

Figure 59).
•
Adjustment accuracy: 0.1 mm
•
Adjustment length: max. 3300 mm
15.2 Calibration of the Digital Cross-Cut Fence
If the dimensions of the digital indicator do not match the ruler scale, the mechanical measuring rulers must
first be readjusted to the fence (see procedure in section

10.6), so that the cut dimensions to the saw blade
are exactly accurate. Only afterwards the fence can be calibrated via the digital indicator.
Figure 60: Display mode mm/ABS
Figure 61: Stored reference dimension (example)
The display should show mm and ABS at the top.
If not, press button
ABS/INCR once.
Note: Depending on the version resp. position and
number of flip stops, different reference dimensions
may appear in the display (see example below).
Example : Calibrating the dimensional setting
•
Keep the buttons ENTER + SET pressed at the
same time
→
The reference dimension stored in
the unit appears. In our example it is the value
“ 1000.0 mm ” (see

Figure 61).
•
Release both buttons and move the flip stop by
hand until it has reached
the exact scale dimension
of 1000.0 mm on the ruler . In this example, a devi-
ating value of 1027.9 mm is shown in the digital
display (see

Figure 62).
Figure 62: Display deviating from reference dimension
•
Keep the buttons ENTER + SET pressed at the same time
→
The correct dimension 1000.0 mm appears and is adopted.
•
The setting is complete (see

Figure 61).

For checking
→
Cut a test piece, remeasure and readjust if necessary.
Repeat the same procedure for the other flip stop (with the corresponding reference dimension). Alternatively,
the digital display can also be calibrated with the ruler measurement in the following way: Simply cut a test
piece and transfer the scale dimension of the flip stop to the display as the reference dimension by simultane-
ously pressing
ENTER + SET .
ENTER SET
ABS
INCR
mm ABS
ENTER SET
ABS
INCR
mm ABS
ENTER SET
ABS
INCR
mm ABS