BA_PH_335-20_EN_07-22.docx
28
9
Commissioning
Read the operating manual and the chapter
4 “Safety” carefully before commissioning and observe them.
Before switching on, check that
•
there are no loose parts on the thicknessing table and that all tools have been removed,
•
the guards are fitted in accordance with regulations,
•
the extraction system is connected and in working order,
•
the direction of rotation is correct,
•
the V-belts are perfectly tensioned
•
and no persons are in a danger zone of the machine
9.1
Switching the Machine ON and OFF
Figure 15: Control panel with main switch
9.1.1
Switching ON
•
Turn the main switch (
H
) to position ”
I
”.
•
Start cutter block with push button (
M
):
The machine starts with automatic star-delta switching.
9.1.2
Switching OFF
•
Switch off the cutter block with push button (
M
):
The machine is braked
•
Turn the main switch (
H
) to position ”
0
”.
Undervoltage protection ensures that the machine is switched off in the event of a power failure and does not
restart automatically when power is applied again.
Note: The machine is equipped with a motor protection switch which switches off the motor
in the event of an overload. In this case, wait a few minutes until the protective contacts
have cooled down again. Only then can the machine be restarted.
H
M
B
A
U
D
N
