BA_PH_245-10_EN_13-22.docx
43
16
Optional Components
16.1
Integral Fence System for Fence Type 216
The optional milling fence 216 can additionally be equipped
with optional integral fence plates. These can be mounted
without tools and in just a few steps instead of the standard
cast fence plates.
The swivelling guide fingers integrated in the fence plates al-
ways ensure a gap-free guide surface and optimum tool cov-
erage for all milling work. This ensures even more safety.
Precise adaptation to the diameter and height of the cutter
is achieved by the stepless adjustment.
Figure 35: Integral fence plates (option)
16.1.1
Operation and Functions
Figure 36: Integral fence plates - operation and functions
The integral plates are available in 3 lengths:
•
Infeed/outfeed side = 500 / 500 mm
•
Infeed/outfeed side = 650 / 500 mm
•
Infeed/outfeed side = 650 / 650 mm
The article numbers can be found in the sec-
tion
“Milling Fences”
.
Pos. Function
1
Height adjustment
2
Fold out guide fingers
3
Move fence plates
16.2
Table Slide Plate
Figure 37: Optional Table Slide
The patented table slide plate (
T
) has coated
surfaces and ensures a safe and quickly adjust-
able tool protection without the need for fur-
ther tools. It is used as an alternative to the
standard table insert rings and can be adapted
to various tools up to Ø 240 mm.
Includes front table insert with quick-locking
device for tools up to Ø 155 mm and a rear in-
sert for closing the table opening. The table
slide plate is available for the standard table
top and for the larger, optional table top.
WARNING: Danger of collision!
When adjusting the tilt of the spindle, the table slide plate must always be completely open.
The article number can be found in the section
“Table Systems”
.
Please note:
The table slide plate cannot be used in combination with the optional turntable.
1
3
2
1
3
T
