Polar Bear III HD Mechanical Attachment Bracket Installation Manual
9910031 Rev F
10
10 Degree Mechanical Attachment location and Mechanical
Attachment Bracket Installation
Step 1: Position the Mechanical Attachment
1.
Consult the provided Racking Construction Set Drawing for the locations of the Mechanical
Attachments that need to be installed. Once the module and Supports are installed you can
locate the Mechanical Attachment. Ballast Trays will need to be removed if they are already
installed.
2.
The Mechanical Attachments are installed north of modules and connect to the underside of the
Ballast Trays via the Mechanical Attachment Bracket.
3.
Center the Mechanical Attachments between two adjacent modules (east to west).
4.
See below for Mechanical Attachment locations from the module edge (
Figure 6, 7
).
NOTE: OMG and Anchor Products are interchangeable for the instructions below.
Figure 6 OMG/Anchor Product: Distance from Support surface to center of Mechanical Attachment
4
11/16
” (±
1/2
”)
120mm (±13mm)
Measure from the
inside surface of
the Support
Measure from the
inside surface of
the Support
6” Standoff
:
4
11/16
” (±
1/2
”)
120mm (±13mm)
Standard Mount
:
5
13/32
” (±
1/2
”)
139mm (±13mm)
Figure 7 EcoFasten Product: Distance from Support surface to center of Mechanical Attachment
