www.panel.it 23
23
5.3 Motherboard jumpers setup
The system is delivered with the optimized defaults preconfigured state and is operational.
Changes in the jumpers settings may only be implemented by appropriately trained staff.
The illustration shows how jumpers are setup. When the jumper cap is placed on pins, the jump
er is “Short”. If n
o jumper
cap is placed on pins,
the jumper is “Open”. The illustration shows a 3
-pin jumper whose pin1 and pin2 are
“S
hor
t” w
hen
jumper cap is placed on these 2 pins.
Jumper N°2 of the motherboard
CLEAR CMOS (
CLRCMOS2)
CLRMOS2 allows you to clear the data in CMOS. The data in CMOS includes system setup information such as system
password, date, time, and system setup parameters. To clear and reset the system parameters to default setup, please
turn off the computer and unplug the power cord, then use a jumper cap to short the pins on CLRMOS2 for 3 seconds.
Please remember to remove the jumper cap after clearing the CMOS. If you need to clear the CMOS when you just
finish updating the BIOS, you must boot up the system first, and then shut it down before you do the clear-CMOS
action.
Default PSG2 factory setting: OPEN
Jumper N°32 of the motherboard
CLEAR CMOS (
CLRCMOS1)
CLRMOS1 allows you to clear the data in CMOS. To clear and reset the system parameters to default setup, please
turn off the computer and unplug the power cord from the power supply. After waiting for 15 seconds, use a jumper
cap to short pin2 and pin3 on CLRMOS1 for 5 seconds. However, please do not clear the CMOS right after you
update the BIOS. If you need to clear the CMOS when you just finish updating the BIOS, you must boot up the system
first, and then shut it down before you do the clear-CMOS action. Please be noted that the password, date, time, user
default profile and MAC address will be cleared only if the CMOS battery is removed.
Default PSG2 factory setting: 1-2
