© Panduit Corp. 2014
Page: 1 of 2
E-mail:
For Technical Support:
1-888-506-5400, ext. 83255
CT-1123 and CT-1104
PA25121A01
REV: 02 10-2014
CONTROLLED CYCLE FERRULE CRIMPING TOOLS
OPERATION, INSPECTION and MAINTENANCE INSTRUCTIONS
1. With the handles in the open position, insert the ferrule
into the crimp pocket. Make sure that the ferrule is
inserted fully into the crimp die (see Figure 2). Close
handles until dies just slightly grip ferrule.
2. Insert the stripped wire into the ferrule until the wire
stops. Refer to ferrule packaging for wire strip length.
3. Crimp the ferrule by closing the handles until the
controlled cycle mechanism releases. Upon release,
the handles will open automatically and the crimped
ferrule can be removed.
NOTE:
Crimp entire uninsulated ferrule length. This may
require additional crimps.
CT-1123 and CT-1104 TOOLS
Cushioned handle grips
Self-adjusting crimp die
for Insulated and non-
insulated ferrules.
Ferrule size dependent on
wire gage.
Refer to ferrule packaging
for proper ferrule and wire
combinations.
Controlled cycle
mechanism prevents tool
from opening before
crimp cycle is
complete.
Fig. 1
Fig. 2
Stripped
Wire
Crimp Die
Ferrule
CAUTION:
Verify power is “OFF” before working on
wiring with these tools.
The plastic grips are for the user’s
comfort, and are not intended
to insulate against electrical shock while
working on live electrical circuits.
CT-1123 Tool
(CT-1104 Tool not shown)
Manual release lever,
push forward in the event
that controlled cycle
mechanism must be
released.
www.panduit.com
