AT-UHD-SW-510W
14
LAN
DC 24V
HDBaseT OUT
HDMI OUT
HDMI IN
DP IN
USB-C IN
2
3
4
1
RELAY
RS-232
TRIGGER I/O
MIRACAST
WiFi
AUX
AUDIO
OUT
L
R
IN
USB
+
C1 COM C2
RX
P
TX
+
+
US
B
US
B
US
B
Connection Instructions
Installation
1. Connect a USB-C cable from a source to the
USB-C (1)
port.
2. Connect a DisplayPort cable from a source to the
DP IN (2)
port.
3. Connect up to two UHD/HD sources, using HDMI cables, to the
HDMI IN (3)
and
HDMI IN (4)
ports.
4. Connect an HDMI cable from the
HDMI OUT
port to a UHD/HD display.
5. Connect up to two USB wireless antenna modules to the
USB
ports. Two USB wireless antennas are included.
The
WiFi
port supports Google Cast™ and Apple AirPlay®. The
MIRACAST
port only supports Miracast™.
The
AUX
port is reserved for obtaining the IP address of the unit and for unit recovery. Refer to
for more information. Note that on hardware revision A, the
MIRACAST
port is labeled as
WiFi
.
IMPORTANT:
Only use Atlona Wi-Fi USB modules. Other Wi-Fi modules may not be supported by
this product.
5
5
6. Connect the relay leads from the control motors of the projection screen, blinds, or curtains, to the relay outputs
to the
RELAY
port, using the included 3-pin captive screw connector. Use a 48 V DC relay with no more than 1
A current draw.
7. Connect a trigger device, such as an occupancy sensor switch, to the
TRIGGER I/O
port. A 4-pin captive screw
connector is required. Voltages from 3 to 30 V are supported.
8. Connect a 3.5 mm analog audio cable from an analog source to the
AUDIO IN
port. This audio source can be
used to embed analog audio on any of the input sources.
9. Connect an Ethernet cable from the
LAN
port to the Local Area Network (LAN).
10. Connect an Ethernet cable from the
HDBaseT
port to an HDBaseT receiver unit, such as the AT-UHD-EX-100CE-
RX-PSE.
11. Connect the included green 5-pin captive screw connector to the
AUDIO OUT
connector.
12. Connect the included power supply to the
DC 24V
connector and connect the power cord to an available
electrical outlet.
13. Follow the on-screen instructions to complete the set-up procedure.
IMPORTANT:
If connecting the AT-UHD-SW-510W to the Local Area Network (LAN), make sure that
the AT-UHD-EX-100CE-RX-PSE is
not
connected to the LAN, as this will create a network loop.