AT-UHD-CLSO-840
46
Value
Description
Compliant
Instructs the source to send HDCP content.
Not Compliant
Instructs the source to send non-HDCP content (if possible) to a non-
HDCP display and/or sink device.
Auto
Allows the input to automatically select the mode, based on the
compatibilities of the display/sink device.
Some devices will automatically transmit HDCP content if an HDCP-compliant display/sink is detected. The AT-
UHD-CLSO-840 provides a method for controlling this behavior. Note that setting this value to
Not Compliant
will
not
decrypt or strip HDCP content from a protected signal.
HDCP Management
Basic Operation
1.
Login to the web GUI. Refer to
Introduction to the Web GUI (page 55)
for more information.
2. Click
HDCP
, under the
Configuration
section in the menu bar on the left side of the screen.
3. Click the
Compliance
drop-down list for the input, and select the desired setting.
4. Click the
Save
button to commit changes. Click
Cancel
to abort changes. To reset HDCP compliance setting to
factory-defaults, click the
HDCP Reset
button near the top of the page.
NOTE:
Setting an input to this value does not decrypt or
“strip” HDCP content from a protected signal.