AT-JUNO-451
16
NOTE:
The AT-JUNO-451 retains the currently selected input, even after the unit is powered-off then
powered-on.
1. Enable auto-switching by using one of the following methods.
Using the web GUI
a.
Login to the web GUI and access the
b. Click the
Auto Switch mode
toggle switch to the
ON
position (if not already in the ON position). This is the
default setting.
2. Connect a source to any of the four input ports on the rear panel. The AT-JUNO-451 will automatically switch to
the port with the connected source. The following rules apply to auto-switching.
• If a source is disconnected, then the AT-JUNO-451 will fallback to a port with an active source.
• If all sources are disconnected, then the AT-JUNO-451 will retain the port of the the last-connected source.
Auto Switching
Auto-switching can also be used to automatically select an input. Auto-switch is enabled by default and must be
enabled for this feature to work. When auto-switching is enabled, the AT-JUNO-451 will automatically switch inputs,
based on the presence of an input signal.
Basic Operation
