Panduit Atlona AT-HDR-SW-52ED, Руководство пользователя

Страница: 61 / 81

AT-HDR-SW-52ED 61
Configuration and Management Interfaces
Display page
CEC Command - HDBaseT Output / HDMI Output
Power: Click the
ON
button to send the power-on command to the display device. Click the
OFF
button to toggle the
power state to off.
Volume: Click the
+
and
-
buttons to adjust the volume. Click the
MUTE
button to test the volume muting function.
Input: Click the INPUT button to cycle between each input.
Consumer Electronics Control (CEC): Atlona has confirmed proper CEC functionality with several current models of Samsung, Panasonic, and
Sony displays. However, it is not guaranteed that CEC will work with all displays. Many manufacturers do not support the CEC “off” command,
and older displays use proprietary commands. Atlona only supports displays that use the CEC command structure defined in HDMI 1.2a. It is rec-
ommended that dealers request an evaluation product from Atlona, before designing a system using the CEC protocol. If this is not possible, then
other control methods will need to be considered, in order to control displays using Atlona products.
CEC
System Settings
Display Auto Power On
Select
Active Video Presence
from this drop-down list to allow the AT-HDR-SW-52ED to send the power-on
command to the display when an A/V signal is detected. When the AV signal is no longer present, the AT-HDR-SW-
52ED will send the power-off command to the display. If this feature is not desired, then set to
Disabled
. The
default settings is
Active Video Presence
.
Auto power off timer
Click this drop-down list to set the time interval before the command to power-off the display is sent, when an A/V
signal is no longer present. The default value is 15 Seconds .
Lamp cool down timer
Click this drop-down list to set the projector lamp cool-down timer, in seconds. This value specifies the time interval
that must elapse, after the display control “off” command is sent, before the display “power on” command can be
sent. This feature is used to prevent the projector from missing a “power on” command while the lamps are cooling.
The default setting is
10 Seconds
.