AT-HDR-SW-51
12
Installation
IP
Configuration
The AT-HDR-SW-51 is shipped with DHCP enabled. Once connected to a network, the DHCP server (if available),
will automatically assign an IP address to the unit. If the AT-HDR-SW-51 is unable to detect a DHCP server within 15
seconds, then the unit will use a self-assigned IP address within the range of
169.254.xxx.xxx/16
. If this occurs,
refer to
Automatic Private IP Addressing (APIPA) Mode (page 14)
.
Use an IP scanner, along with the MAC address on the bottom of the unit, to identify the unit on the network. If a
static IP address is desired, the unit can be switched to static IP mode.
NOTE:
When switching between DHCP and static IP mode, the AT-HDR-SW-51 will retain
the last assigned IP address until it is changed manually (static IP mode) or assigned a new IP
address by the DHCP server.
1. Make sure the AT-HDR-SW-51 is powered.
2. Connect an Ethernet cable between the
LAN
port of the AT-HDR-SW-51 and the Local Area Network (LAN).
3.
Press and hold the
POWER
button for approximately 15 seconds. Release the
POWER
button once all the front-
panel LED indicators begin to flash. The number of flashes will indicate the currently selected IP mode. Refer to
the table, below.
Button flashes
Description
Settings
Two
Static IP mode
IP address:
192.168.1.254
Subnet mask:
255.255.0.0
Gateway:
192.168.1.1
Four
DHCP mode
DHCP server assigned
Using the Front Panel
L
R
S/PDIF
1
2
3
4
5
HDMI IN
HDMI OUT
LAN
FW
DC 5V
+
-
RS-232
RX TX
AUDIO OUT
AT-HDR-SW-51
POWER
INPUT
HDMI 1
HDMI 2
HDMI 3
HDMI 4
HDMI 5
POWER button
