IP/SERIAL DRIVER FOR ATLONA AT-H2H-HDR-44MA AND AT-H2H-HDR-88MA
This driver allows you to control an Atlona HDMI AT-H2H-HDR-44MA or 88MA 4K Matrix Switcher (4x4 or
8x8) from Control4.
The AT-H2H-HDR-44MA and AT-H2H-HDR-88MA matrix switchers have a separate set of analog audio
outputs which carry de-embedded audio form the corresponding input HDMI source. Commands are
available to mute/unmute these audio outputs.
----------------------------------
INSTALLATION INSTRUCTIONS
•
Ensure the Atlona Switcher
fir
mware is at the most recent level.
•
You should set the Atlona Switcher to a sta
�
c IP address or ensure it always receives the same
IP address from the DHCP server via a MAC-based reserva
�
on.
•
When using Serial control (by itself or as a backup to IP control), make the appropriate Serial
Switch Control connec
�
on. If both IP and Serial are connected and IP fails, the driver will use
Serial and revert back to IP when restored. For Serial control, the driver only supports the baud
rate of 115200. Make sure your matrix baud rate is set to match.
•
Connect the HDMI Inputs, the HDMI Outputs and op
�
onally the Analog Outputs as appropriate.
•
Adjust the ‘Power O
ff
when Unused’ and ‘On Room O
ff’
proper
�e
s as required. See below for
descrip
�
ons.
----------------------------------
PROPERTIES
Driver Version
shows the version of this driver.
Driver Informa
�
on
shows various status messages about the driver.
Debug Mode
turns Debug Mode On or O
ff
(with output to the Lua Output window).
Debug Dura
�
on in Minutes
sets the dura
�
on of Debug On.
Switcher Available via IP
shows if the Matrix Switcher is connected to the driver using IP.
Switcher Model
shows the model of the actual device connected to the driver.
Power O
ff
when Unused
determines what the Switcher will do when Control4 determines that
none of its outputs are in use. When set to Yes, the driver will power the Switcher O
ff
when all its
1
AT-HDR-H2H-44MA
AT-HDR-H2H-88MA
Control4 driver
