AT-UHD-CAT-4ED
6
The Atlona
AT-UHD-CAT-4ED
distribution amplifier featuring pass-through HDMI input connections, four extended
distance, Ethernet-enabled HDBaseT outputs and display control capability. Each output transmits AV and control
signals up to 330 ft. (100 m). Features include 4K/UHD @ 60 Hz with 4:2:0 color subsampling, HDCP 2.2 compliance,
EDID management, and PoE for powering remote receivers. A wide variety of consumer displays may be controlled
by the UHD-CAT-4ED using CEC*. Designed for commercial distribution applications, the UHD-CAT-4ED is control
system-friendly and integrates with any TCP/IP, RS-232, or IR control system and features a 1U, half-rack width
enclosure with external, international power supply. Compatible Atlona receiver: AT-UHD-EX-100CE-RX.
Introduction
Features
Package Contents
•
HDMI distribution amplifier with built-in HDBaseT transmission
•
Four HDBaseT outputs for transmission of HDMI, Ethernet, and control up to 330 feet (100 meters)
•
4K/UHD capability with HDCP 2.2 copy protection
•
Power over Ethernet (PoE) for HDBaseT receivers
• CEC display control
• Multi-channel audio compliant
• EDID management
•
Intuitive GUI-based configuration using integrated web server
•
TCP/IP, RS-232, and IR control
•
Easy to configure and manage with AMS (Atlona Management System)
•
Field-updatable firmware
• Front panel power and signal status LEDs
• Rack-mountable 1U, half rack width enclosure
• Award-winning 10 year limited product warranty
1 x AT-UHD-CAT-4ED
1 x IR emitter (AT-IR-CS-TX)
3 x 5-pin captive screw connector
2 x Mounting Plates
1 x Rack Ear (long)
1 x Rack Ear (short)
4 x Screws (MAS-MF03+04D1 for Mounting Plate)
4 x Screws (MAS-MF04+06D for Rack Ear)
1 x 48 V / 2.08 A power supply
1 x AC cord
1 x Installation guide
*Consumer Electronics Control (
CEC): Atlona has confirmed proper CEC functionality with several current models of Samsung, Panasonic, and
Sony displays. However, it is not guaranteed that CEC will work with all displays. Many manufacturers do not support the CEC “off” command,
and older displays use proprietary commands. Atlona only supports displays that use the CEC command structure defined in HDMI 1.2a. It is
recommended that dealers request an evaluation product from Atlona, before designing a system using the CEC protocol. If this is not possible,
then other control methods will need to be considered, in order to control displays using Atlona products.
