AT-UHD-CAT-4ED
25
Device Operation
Power Button Modes
The main function of the
POWER
button on the front panel is to toggle the AT-UHD-CAT-4ED between standby and
normal operating mode. This is the default mode. However, this button can also be defined to send CEC power-
on and power-off commands, over HDBaseT, to the display (sink) devices. It can also be defined to simultaneously
power-on or power-off the AT-UHD-CAT-4ED and any connected displays.
Normal Operation
By default, pressing the
POWER
button will toggle the power state of the AT-UHD-CAT-4ED. When the unit is in
normal operating mode, the
POWER
button will be blue. Pressing the
POWER
button again, will place the unit
into standby mode, and the
POWER
button will be red. In standby mode, no video signal will pass to the display
(sink) device. However, TCP/IP access to the unit will be maintained, allowing access to the web server and Telnet
sessions.
1. Launch a web browser and login to the web server. Refer to
Introduction to the Web Server (page 29)
information. The factory-default username and password are listed below:
Username:
root
Password:
Atlona
2. Click
System
in the menu bar.
3. Click the
Power button mode
drop-down list and select
DA standby
. Pressing the
POWER
button on the front
panel will toggle between power-on and standby modes on the AT-UHD-CAT-4ED. Connected display (sink)
devices will not receive CEC power-on / power-off messages.
