AT-UHD-CAT-4ED
16
Device Operation
Selecting EDID
Presets
The AT-UHD-CAT-4ED comes with a default EDID plus 16 pre-programmed EDID selections. When selecting the
default or one of the pre-programmed EDID selections, the EDID mode must be set to
INT
(internal) mode.
Available EDID selections are presented in the table below.
1. Login to the web server. Refer to
Introduction to the Web Server (page 29)
for more information.
2. Click
EDID
in the menu bar.
3. Make sure the
EDID lock
toggle switch is set to
UNLOCK
.
4. Click the
EDID mode
drop-down list and select
INT
.
5. Select the desired EDID from the
INT EDID settings
drop-down list.
The selected EDID will be used by the source, before sending A/V data to the display (sink) device.
NOTE:
If the resolution and timing limitations of all displays, connected to the
HDBaseT OUT
ports,
are unknown, then select the
STD
EDID for the best compatibility. The
STD
EDID will automatically
build an EDID based on the capabilities of all connected displays. When selecting an EDID, make
sure all connected displays can support the resolution and timing information. Otherwise, loss of
picture and/or audio may result.
EDID
STD
ATL 1280x800 RGB 2CH
ATL 1080P 2CH
ATL 1366x768 RGB 2CH
ATL 1080P Multi CH
ATL 1080P DVI
ATL 1080P DD
ATL 1280x800 RGB DVI
ATL 1080P 3D 2CH
ATL 3840x2160@30 2CH
ATL 1080P 3D Multi CH
ATL 3840x2160@30 Multi CH
ATL 1080P 3D DD
ATL 3840x2160@60 2CH
ATL 720P 2CH
ATL 3840x2160@60 Multi CH
ATL 720P DD
