AT-HDR-CAT-2
11
DC 48V
LAN
HDMI
AUDIO OUT
IN
OUT
IR
RS-232
RX TX
RX
TX
MASTER
1
2
HDBaseT OUT
RX
RX
TX
TX
RS-232
IR
R
L
1
2
FW
EDID
AT-HDR-CAT-2
POWER
INT
LOCK
2
1
OUT
IN
HDMI
LEARN
HDBaseT
Installation
IP
Configuration
1. Make sure the AT-HDR-CAT-2 is powered.
2. Connect an Ethernet cable between the
LAN
port of the AT-HDR-CAT-2 and the Local Area Network (LAN).
3.
Press and hold the
POWER
button for approximately 15 seconds. Release the
POWER
button once all the front-
panel LED indicators begin to flash. The number of flashes will indicate the currently selected IP mode. Refer to
the table, below.
POWER button flashes
Description
Two
Static IP mode
IP address:
192.168.1.254
Netmask:
255.255.0.0
Gateway:
192.168.1.1
Four
DHCP mode
Setting the IP Mode
LOCK LED indicator
POWER button
NOTE:
When switching between DHCP and static IP mode, the AT-HDR-CAT-2 will retain the last
assigned IP address until it is changed manually (static IP mode) or assigned a new IP address by the
DHCP server.
The AT-HDR-CAT-2 is shipped with DHCP enabled. Once connected to a network, the DHCP server (if available),
will automatically assign an IP address to the unit. If the AT-HDR-CAT-2 is unable to detect a DHCP server within 15
seconds, then the unit will use a self-assigned IP address within the range of
169.254.xxx.xxx/16
. If this occurs,
refer to
Auto IP (APIPA) Mode (page 13)
Use an IP scanner, along with the MAC address on the bottom of the unit, to identify the unit on the network. If a
static IP address is desired, the unit can be switched to static IP mode.
Using the Front Panel
