AT-ANC-108D
27
Device Operation
System Configuration
The AT-ANC-108D provides easy access to system configuration through the built-in web server, and is the
recommended method to adjust network settings.
Changing the
Network IP Mode
By default, the AT-ANC-108D is set to DHCP mode. Once connected to a network, and if a DHCP server is found (or
available), the AT-ANC-108D will be assigned an IP address on the network, and no further network configuration is
required. However, if the AT-ANC-108D is unable to detect a DHCP server within 15 seconds, then the unit will use
the default static IP address of
192.168.1.50
. The instructions below will focus on setting the AT-ANC-108D to static
IP mode.
IMPORTANT:
Before assigning a static IP address to the AT-ANC-108D, it is recommended to
consult with the network or system administrator and obtain a available IP address. If the AT-ANC-
108D is assigned an IP address which is already in use by another device, it may cause either
network issues and/or the AT-ANC-108D will be not accessible.
1.
Login to the web server. Refer to
for more information.
2. Click the
System Settings
tab.
3.
Locate the
IP Mode
toggle switch. The default setting of this toggle switch is
DHCP
.
4. Click this toggle switch to set it to
STATIC IP
.
5.
Enter the desired IP address for the
AT-ANC-108D in the
IP
field.
6.
Enter the subnet mask and gateway address in the
Netmask
and
Gateway
fields, respectively.
7. Click the
Save
button to commit changes. Changes will take effect immediately.