EN
- 19 -
4.4.- CORIAN VERSION REMOTE CONTROL:
(optional in some models, consult distributor)
SYNCHRONISING THE CONTROL WITH THE HOOD:
When the hood is installed or if a change is made in the transmission code,
it is necessary to synchronise
the control with the hood control unit. The process is as follows: Disconnect and then reconnect the
power supply to the hood (with the hood control unit switch or by unplugging the hood, or with the circuit
breaker switch on the home electric panel), when the hood has ben reconnected to the mains supply,
before 20 seconds have passed press the light key with the remote control pointing to the hood, the hood
will light up, indicating that the process was correct.
If more than 20 seconds pass before you synchronise the control, the control unit will close the reception
and no code will be recorded.
Attention!: Synchronisation of the remote control with the hood can be lost due to external reasons such as power
cuts, electrical discharges, interference….In these cases it is necessary to repeat the synchronisation process.
GENERATING A NEW TRANSMISSION CODE:
1
Hood motor on and off.
2
Reduce motor speed.
3
Increase motor speed.
4
Motor timer, keeps the hood on for 10 minutes and then switches it off.
5
5. Led indicator of control key pressed. Also indicates programming process.
6
Light on and off. *.
* A short press switches the main light on or off, and in models with a courtesy
light, this is controlled with a long push, keeping the key pressed for more than 2
seconds.
6
5
4
3
2
1
3
2
1
The manufacturer supplies the remote control ready for use, with the
factory default codes.
If you want to generate new codes, do the following: Press simultaneously
and keep pressed the three keys indicated in the illustration (1-2-3)
until the LED (5) begins to flash, at that moment the control is going
through the different frequencies available, when you release the keys,
the led (5) will stop flashing and record the frequency being scanned
at that moment.
If you want a different frequency, repeat the process (after re-establishing the factory default configuration),
and the chosen frequency will depend on the time you keep the keys pressed.
ATTENTION! This operation will definitively delete the existing codes.
