AT-OME-ST31A
25
Configuration and Management Interfaces
The
A/V Settings
page is divided into three sections:
Video
,
Audio
, and
HDCP
. The
Video
section allows the
preferred input timing to be selected as well as whether or not HDCP content is allowed to pass. The
Audio
section provides options to control the output audio volume, muting, treble, and bass. The
HDCP
section provides
management of HDCP and non-HDCP content.
Input Selection
Click this drop-down list to manually select the desired input.
Input
Description
USBC
Sets
INPUT 1
as the active input.
HDMI1
Sets
INPUT 2
as the active input.
HDMI2
Sets
INPUT 3
as the active input.
Input
Description
Previous
Automatically switches to the input that was connected last.
USBC
Switches to the
INPUT 1
.
HDMI1
Switches to the
INPUT 2
.
HDMI2
Switches to the
INPUT 3
.
Auto Switch
Three controls are available under the Auto Switch feature.
• Auto Switch
Click this toggle switch to enable or disable auto-switching. When enabled, the AT-OME-ST31A will
automatically switch to the another port, if the signal is disrupted on the currently active input. The port to be
switched to, is defined in the
Fallback Input
drop-down list. Refer to
for more
information.
• Fallback Input
Click this drop-down list to select the fallback port. If the source is disconnected from the active port, then the
switcher can be configured to automatically switch to the desired port. Click the
Auto Switch mode
toggle to
enable or disable auto-switching.
A/V Settings Page
