P&E Microcomputer Systems Cyclone LC Series, Руководство пользователя

Страница: 60 / 149

User Manual For Cyclone LC Programmers 60
In the case of a Cyclone present on a different network (i.e., not displayed automatically in the
drop-down list), the user may specify its IP address by using the Specify Cyclone checkbox and
typing the identifier of the Cyclone.
Click on "Connect" to access the specified Cyclone. A click on the "Apply Changes" button will
then store the image on the selected Cyclone.
6.1.11 Store Image To Disk
“Store Image To Disk” allows the current configuration to be saved onto the hard drive. The image
can then be transferred to the Cyclone’s internal flash (or an installed SD card) via the Manage
Images Utility.
6.1.12 Save Cyclone Configuration
“Save Cyclone Configuration,” in the file menu, allows the user to save the configuration into a file,
which may be used for future reference, e.g., comparing the Cyclone contents with the file to see if
they are the same.
6.1.13 Load Cyclone Configuration
“Load Cyclone Configuration” in the file menu allows the user to load a configuration that has
previously been saved in order to create a new image.
6.2 Managing Multiple SAP Images
The Cyclone Control GUI, shown below in Figure 6-25 , allows the Cyclone to store and manage
multiple images in the Cyclone’s internal memory and - on a Cyclone FX or a Cyclone LC with the
SDHC Port Activation License installed - on any compatible memory card that is loaded into the
SDHC port (
CYCLONE programmers require SDHC License Activation).
Any programming images that have been created and saved to the disk using the Cyclone Image
Creation Utility may be loaded collectively onto the Cyclone, with one exception. Encrypted images
may only be loaded if their ImageKey resides on the Cyclone.