* * ADVISEMENT * *
Read instructions completely prior to
starting installation. All InDash Mounts
are designed so that after installation, phone
is facing normal driver position for left-
hand drive vehicles. This mount is not
designed to be used in foreign countries
with right-hand drive vehicles. Use extreme
care when working around the plastic
components on the dash. Excess force, can
cause breakage of the plastic components.
C
ELL
P
HONE
& M
EDIA
M
OUNT
I
NSTALLATION
I
NSTRUCTIONS
I-751171106
Page 1 of 2
There may be recent updates to this Instruction Sheet, please visit our website or contact PanaVise Products, Inc. for the latest revision as well as for the
most complete up-to-date PanaVise InDash Applications List: 7540 Colbert Dr., Reno, NV, Phone: 800.759.7535, 775.850.2900, Fax: 800.395.8002,
www.panavise.com. © 2002 PanaVise Products, Inc.
12-20-11
MOUNTING LOCATION:
Left or Right side of RadioJ LR
TOOLS REQUIRED:
Small Flat Screwdriver,Taped
Phillips screwdriver
5/16" socket driver
HARDWARE INCLUDED:
(2 ) O - 8-32 Acorn Nut
(1)S7-1854 & (1)75002 & (1)75001
PART#: 751171106
MFG: HONDA/SUZUKI
MODELS & YEARS:
HONDA-Ridgeline 06-12(W/O Nav)
(3-Pieces Mount for L or R Mounting)
SUZUKI-Forenza 05-08 (Pg.2)
STEP #1: With taped flat screwdriver to protect
dash. Insert it into small slot between bezel and dash,
at the bottom of large bezel that surrounds the radio
and instrument panel to the right of the steering
column. Pry to release (1) clip. With your hands pull
on hte dash bezel to release More clips, (1) above
the last one and (12) more clips that surround the
radio and the top of the dash bezel.
STEP #2: With the Phillips screwdriver remove the
(1) screw to the center Right or Left side of the
radio buttons. Install the bottom part over the screw
hole and guide pin. Replace the screw.
STEP #3: Replace the large bezel, being sure to get
all clips completly back in place. Install desired Top
part (There are (2) top pieces one for right side of
radio, and one for left side of radio) by inserting
the studs into the holes on bottom part and installing
the (2) cap nuts onto the studs with the
5/16" socket driver.
INSTALLATION IS NOW COMPLETE.
ENJOY YOUR NEW INDASH by PANAVISE
MOUNT.
(A) Part installed with bezel
replaced
Prototype (A) Part installed
showing location
InDash installed showing
Right Side location
Prototype (A) Part installed
showing location
(A) Part installed with bezel
replaced
InDash installed showing
Left Side location
