Panasonic WV-X6511N, Руководство по эксплуатации

Страница: 74 / 265

•
200%: Displays in 200% of the standard size.
•
Default: 100%
IMPORTANT
•
If the settings for [Date/time position] and [Camera title position] are different, the frame rate may be
lower than the specified value.
•
If the settings for [Date/time position] and [Camera title position] are different, characters may be
displayed incorrectly or overlapped depending on the [Character size] setting and the number of
characters used. After completing the settings, confirm the result on the “Live” page.
•
If “150%” or “200%” is selected for [Character size], the frame rate may be lower than the specified
value.
•
Depending on the setting and the numbers of characters used for [Character size] and the image
capture size, characters displayed on the screen may be cut off. After completing the settings, confirm
the result on the “Live” page.
[Brightness status display]
Select “On” or “Off” to determine whether or not to display the status of brightness on images displayed on the
“Live” page when adjusting brightness.
•
Default: On
[Stabilizer]
Select “On” or “Off” to determine whether or not to activate the image stabilizer. This is not available when “2
mega pixel [16:9](60fps mode)” or “1.3 mega pixel [16:9](60fps mode)” is selected for “Image capture mode”.
•
Default: Off
Only use the stabilizer function if the camera is installed in an environment that is subject to frequent vibrations.
The stabilizer function can reduce the shaking in images.
Use this function after checking operations when installing the camera.
Do not use the stabilizer function if the camera is installed in an environment that is not subject to vibrations.
If the stabilizer function is used in such a case and there is a moving subject, the stabilizer function will correct
the image and this may cause it to appear as if the entire screen is shaking.
IMPORTANT
•
If “On” is selected for “Stabilizer”, the view angle will become narrower. When “On” is selected, check
the view angle at camera installation.
•
If “On” is selected for “Stabilizer”, the noise in images may be increased.
•
If “On” is selected for “Stabilizer”, “Stream(3)” and “Stream(4)” become “Off”.
•
If “On” is selected for “Stabilizer”, “Smart Facial Coding” of “Smart Coding” for “Stream(1)” becomes
“Off”.
•
The stabilizer is not available under the following conditions:
–
In the auto mode (auto track)
–
During position refresh
•
Depending on the photographic conditions such as in the following situations, images may not be able
to be effectively stabilized.
–
When subjects are dark
–
Subjects with short-cycled image shaking, such as mechanical vibration
–
Subjects with large-amplitude image shaking
–
Auto mode (Auto pan, Preset sequence, Patrol)
–
VMD alarm setting
–
Image/Position setting
–
During pan/tilt operation
•
When capturing images of large subjects that are moving, stabilization may malfunction.
74 Operating Instructions
2 Settings