Panasonic WV-X6511N, Руководство по эксплуатации

Страница: 134 / 265

From “Destination of notification”, check the “Alarm” checkbox of “Address 1” (any notification
destination address can be selected), and enter 192.168.0.12 in “Destination IP address”.
Set “Auto track cooperation” to “On”, and select “1” for the alarm area number.
Click the [Set] button.
4.
Configure the settings of Camera 2 (IP address: 192.168.0.12), which receives notification commands from
the other cameras.
Display the “Alarm” screen from the “Alarm” page. (
®
Page 149)
From “Alarm”, set “Command alarm” to “On” and click the [Set] button.
Set the “Command alarm” of “Camera action on alarm” to “Preset per sender”, and click “Preset per
sender >>”.
On the “Preset per sender” setup menu (
®
Page 156), check the “Auto track cooperation” checkbox
of “Sender’s address 1” (any destination address can be used) and enter 192.168.0.11 (Camera 1) for
the sender’s address. Then select the preset position set at step 2, click the [Set] button, and then close
the page.
Click the [Set] button.
5.
Auto track cooperation can be used by starting the auto tracking for Camera 1.
Note
•
During auto tracking, “Stabilizer” and “Smart Facial Coding” will not be operated.
2.5.5.7 Configure the settings relating to direction/angle setting
(“Direction/Angle setting” setup menu)
Click the [Setup>>] button of “Direction/Angle” on the [Image/Position] tab of the “Image/Audio” page
(
®
Page 107).
Here, the information related to the direction/angle setting is set. The pan/tilt position moves to the position set
as north when displaying this page.
134 Operating Instructions
2 Settings