[CA Certificate - Information]
Displays the information of the CA certificate (Security certificate).
When the [Confirm] button is clicked, the registered information of the installed CA certificate (Security
certificate) will be displayed in the “CA Certificate - Confirm” dialog box. If the CA certificate (Security certificate)
is not installed, the content of the generated CSR file will be displayed.
When the [Delete] button is clicked, the installed CA certificate (Security certificate) will be deleted.
IMPORTANT
•
Before deleting the valid CA certificate (Security certificate), confirm that there is a backup file of the
CA certificate (Security certificate) on the PC or another media. The backup file of the CA certificate
(Security certificate) will be required when installing the CA certificate (Security certificate) again.
Note
•
After changing the connection setting, access the camera again by after waiting a while according to
the changed setting (“http://IP address of the camera” or “https://IP address of the camera”).
•
When the camera is accessed using the HTTPS protocol, the refresh interval and frame rate of images
may be lower.
•
When the camera is accessed using the HTTPS protocol, it may take time to display images.
•
When the camera is accessed using the HTTPS protocol, the images may be distorted.
•
The maximum number of concurrent access user varies depending on the maximum image size and
transmission format.
2.8.2.3 Configure the QoS settings
The settings relating to the Diffserv function and shaping of stream are configured in this section.
Diffserv
The Diffserv function can be used to set the priority of image/audio data sent from routers.
The priority set to this function must match the DSCP value configured to the router.
When using the Diffserv function, contact the network administrator.
[Image DSCP(0-63)]
Enter the packet priority for video data.
•
Available values:
0 - 63
•
Default:
0
64
Operating Instructions
2 Settings
