Panasonic VL-V901, Инструкция по установке и эксплуатации

Страница: 53 / 96

5.2.13 List of PC programming parameters
The following parameters are available when using PC programming.
Control Box — Room settings
*1
Parameter Description and available settings Default
Room No. Determines the room number of the main monitor
connected to the corresponding control box port,
distribution box number, and distribution box port.
(1–99999; 0 is displayed when the room is not
configured) —
Floor No. Determines the floor number setting of the
corresponding room number.
(0–99; 0 is the ground floor) 0
Lift access permission (Lift 1–3) Determines which lifts can be used by visitors to each
lobby station. 0
(No lifts can be
used)
Control Box — General settings
Parameter Description and available settings Default
Monitor Time Out Determines the amount of time that passes when
watching camera images before the standby screen is
displayed.
[0]: 180 SEC
[1]: 90 SEC
[2]: 60 SEC
[3]: 30 SEC 0
(180 SEC)
Talk Time Out Determines the amount of time that passes when
talking before the standby screen is displayed.
[0]: 90 SEC
[1]: 60 SEC
[2]: 30 SEC
[3]: 180 SEC
[4]: 300 SEC 0
(90 SEC)
Camera Signal Tells the system what signal format is used by the
external camera.
[0]: PAL
[1]: NTSC 0
(PAL)
Lift Signal Mode Determines the signalling method used by the lift
controller to communicate with the lift. Select the signal
type according to the specifications of the lift.
[0]: RELAY
[1]: BINARY 0
(RELAY)
Lift Signal Time After a visitor is admitted, this setting determines the
amount of time that the visitor can use the lift to visit the
corresponding floor.
If the lift has a similar setting, set this parameter to any
value other than "0"; the lift setting will take priority.
(1–900 SEC, or 0 to disable) 300
(300 SEC)
Visitor Call Mode Determines if visitors can call rooms directly or if their
calls are directed to a reception terminal.
[0]: ROOM MODE
[1]: RECEPTION MODE 0
(ROOM MODE)
Terminal 1–4 Extension Number Tells the system the extension number for terminal 1–
4. (24 digits max.) —
53
5. Programming