Panasonic VARICAM LT, Руководство по эксплуатации

Страница: 166 / 182

– 166 –
Chapter 11 Network Connection — Connecting the remote operation panel (AK-HRP200G)
Connecting the remote operation panel (AK-HRP200G)
Part of the function can be remotely controlled by connecting the remote operation panel AK-HRP200G (optional) via IP connection.
Playback operation is not possible from the remote operation panel AK-HRP200G. Playback can only be performed from the camera.
LAN cable (cross cable) (optional)
AK-HRP200G
Setting for connection with the remote operation panel (AK-HRP200G)
To connect AK-HRP200G via network to set the camera to the remote control mode, configure the settings in the following procedure.
1
Configure the network settings of the camera.
Set [MENU] → [PERIPHERAL] → [LAN PROPERTY] → [DHCP] to [DISABLE], and set following the Steps
1
to
2
in “Wired LAN settings”
(page 162).
2
Set each item in [MENU] → [PERIPHERAL] → [NETWORK FUNC] → [USER ACCOUNT] in the camera.
[USER NAME]: Sets the user account name. (Factory setting: [guest])
[PASSWORD]: Sets the password. (Factory setting: [p2guest])
Enter up to 31 characters for a user account, and characters between 6 and 15 for a password.
3
Configure the network settings of AK-HRP200G.
For the network settings, use the ROP setup software application supplied with AK-HRP200G.
@ @ NOTE
t
The following information is required to connect to AK-HRP200G.
- User account name
- Password
- IP address
- Port number: 49152
t
Use versions above Ver3.00.00 for AK-HRP200G.
t
For details on operating the ROP setup software, refer to AK-HRP200G operation manaul.
t
Use versions above Ver3.00.00 for ROP setup software.