Panasonic UF-6300, Руководство по обслуживанию, Страница: 119 / 274

119
200 RCV C Decoding process is not completed
at the end of phase C. Defective SC PCB.
212 XMT
RCV A-E Interface error occurred between
the CPU and modem. Modem is defective. (SC PCB)
Software problem occurred. (SC PCB)
301 XMT
RCV - System fault. Software problem occurred. (SC PCB)
331 XMT C 8-minutes timer error.
(Germany only)
390 STANDBY
RCV
PRINT
- Interface error occurred between
the machine and the PC. Firmware update error.
GDI print error.
(Perform the operation again)
400 XMT B T1 timer (35±5 sec.) elapsed
without detecting 300 bps signal. Wrong number is dialed and the START
button is pushed.
Telephone line is disconnected while
dialing.
SC PCB (Modem) or MJR PCB are
defective.
Receiver is defective. (It may only be
transmitting CED)
401 XMT B DCN was returned from receiver
while transmitter is waiting for CFR
or FTT. Your machine's ID Number is not
programmed.
Possible incompatibility or incorrect
Password.
402 XMT B DCN was returned from receiver
while transmitter is waiting for NSF/
DIS. Receiver working in non-CCITT mode
only. (Possible incompatibility)
403 RCV
(Polling)
B Transmitter had no polling function. "POLLED=ON" (polling XMT ready) is
not set at the transmitter.
Document to be transmitted is not
placed at the transmitter.
404 XMT B Transmitter sent NSS (or DCS)
followed by TCF three times, but
the receiver did not respond. (CFR
or FTT is usually returned) Receiver is defective. (Modem, MJR
PCB, etc.)
SC PCB or MJR PCB are defective.
Receiver disconnects line during first
NSS (or DCS) is transmitted.
405 XMT B Transmitter received FTT after it
transmitted TCF at 2400bps.
Received RTN after communicating
at 2400 bps. Line quality is poor. (TCF is damaged
due to line noise)
Receiver is defective. (Modem, etc.)
SC PCB or MJR PCB are defective.
406 RCV
(Password
Comm.)
B XMT-Password mismatched.
RCV-Password mismatched.
Selective RCV incomplete. XMT, RCV password does not match.
Last 4 digits of TSI does not match with
the last 4 digits of ONE-TOUCH, ABBR
telephone number.
407 XMT D Transmitter received no response
after it transmitted post message,
such as EOP, MPS, EOM, etc...or
received DCN. Receiver is defective. (No paper, paper
jamming, etc.)
Receiver ceased receiving because of
excessive error. (Line quality is poor)
SC PCB (Modem) or MJR PCB are
defective.
408 XMT D Transmitter received RTN after it
transmitted EOP, MPS, or EOM. Receiver receives data with error. (Line
quality is poor)
Receiver is defective. (Modem, etc.)
SC PCB or MJR PCB are defective.
Fax Information Codes
Code Mode Phase Description of Problem Cause