Panasonic TX-P50VT60T, Руководство пользователя

Страница: 77 / 218

- 77 -
Note
●
TV Guide may also be used to set timer programming event.
Watching TV Guide Timer Programming
●
Timer Programming can store up to 15 events.
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
For recording using Timer Programming , the TV must be either on or in
Standby. For reminders to be displayed, the TV must be on.
●
Depending on the progress of recording, analogue channel may not be
selected.
●
Recording an encrypted (copy-protected) programme may not be possible.
●
2 minutes before the starting time, a reminder message may appear if you
are watching TV.
– To remove the message and start the programming, press
OK .
– To cancel the programming, press EXIT .
●
LED will turn to orange in Standby mode if Timer Programming is set.
●
Timer Programming reminder messages will remain displayed until one of
the following occurs:
– You press
OK to view the programme or EXIT to cancel the reminder.
– The timer programming event that the reminder is set for ends.
●
“!” identifies that three or more timer programming events are overlapped.
USB HDD Rec. is given priority over Reminder . As for the overlapped
recording events, the first event starts and finishes as programmed. The
next event can then start.
●
The recording of Timer Programming may automatically change the
channel to the programmed channel a few seconds before the starting
time.
●
The recording of Timer Programming will be performed even if the TV is
in REW LIVE TV recording. In this case, REW LIVE TV recording will be
cancelled.
Recording Recording current programme REW LIVE TV
●
For more information of the USB HDD
Recording Technical information