37
Security Measures
You can set the password and/or enable/disable some functions for security purpose.
z
Other security measures
• SD Security (
• Embedded Security (TPM) (
): For further information, refer to the
Installation Manual
of “Trusted Platform
Module (TPM)”.
Set the Supervisor Password before setting the User Password.
1
Start up the Setup Utility (
2
Select [Security].
3
Select [Set Supervisor Password] or [Set User Password], and press
Enter
.
4
Enter your password in [Enter New Password] and press
Enter
.
z
When the password has been set, you need to enter your password in [Enter Current Password] and press
Enter
.
z
To disable the password, leave the input field empty and press
Enter
.
5
Enter your password again in [Confirm New Password] and press
Enter
.
6
In [Setup Notice], press
Enter
.
7
Press
F10
, and then select [Yes] and press
Enter
.
CAUTION
z
Do not forget your password. If you forget your Supervisor Password, you will not be able to use your computer. Con-
tact technical support office.
z
When running the Setup Utility, do not leave and go away from your computer even for a short time, since other people
may set or change the password.
NOTE
z
The password will not be displayed on the screen.
z
You can use up to 32 alphanumeric characters (including spaces).
• The case (upper/lower) is ignored.
• Use only the upper horizontal row of numeric keys to input your password.
• You cannot use
Shift
and
Ctrl
to input a password.
z
Disabling the Supervisor Password also disables the User Password.
Setting the Supervisor Password/User Password
