Panasonic SD XC WV-SFN480, Руководство по эксплуатации

Страница: 102 / 220

Register the preset positions
1.
Select a preset position number. When registering with Single PTZ, numbers 1 to 16 can be selected.
When registering with Quad PTZ, combinations of 1-4, 5-8, 9-12, or 13-16 can be selected.
→
The selected preset position number will be displayed in the “Position No” area.
When the selected number has already been registered, the camera will move to the selected preset
position.
2.
Move the image position to the desired direction.
•
The image position is changed with fisheye control.
3.
To display the preset ID on the “Live” page, enter the desired position title. In Quad PTZ, 4 position titles
can be configured.
•
Leave this field blank when you do not want to display the preset ID.
4.
The setting for “Dwell time” can be configured for each position independently.
5.
Click the [Set] button.
Position No
[Preset ID (0-9,A-Z)]
Enter the preset ID to be displayed on images. This function can be applied to each preset position.
•
Available number of characters: 0 - 20 characters
•
Available characters: 0-9, A-Z and the following marks. ! " # $ % & ' ( ) * + - , . / ; : = ?
•
Default: 1: HOME1/ 2: HOME2/ 3: HOME3/ 4: HOME4/ 5 and subsequent numbers are blank.
Note
•
When the image type is Quad PTZ or Single PTZ, the home position is set in advance in the following
manner.
–
Quad PTZ: position numbers 1 to 4
–
Single PTZ: position number 1
•
The entered preset ID will be displayed next to the preset position number on the pull-down menu.
When the image type is Quad PTZ, the preset ID of the lowest number preset position is displayed.
[Dwell time]
Select a dwell time (duration the image stops for at each preset position) for the preset sequence operation.
5s/ 10s/ 20s/ 30s
•
Default: 10s
Fisheye Control
For information on how to perform operations, refer to page 13.
[Set] button
Registers the preset positions.
[Delete] button
Deletes the preset position specified by the position number.
Note
•
If position numbers 1 to 4 are deleted, the default positions are set.
•
In Quad PTZ, if a preset position is deleted, all 4 preset positions are deleted at the same time.
•
In Single PTZ, even when position 1 is not selected, “1” is displayed on the “Fisheye Control” window.
[Close] button
Click this button to close the “Preset position” setup menu.
11.5.4 Configure the preset positions (Initial position setup menu)
Click the [Setup>>] button of “Preset position” on the [Image/Position] tab of the “Image/Audio” page.
(
®
page 91)
102 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]