10
T
Q
BJ
233
8
Placing the main unit in a rack or on a table
Additionally required accessories (commercially available)
Fall prevention cord (x2)
Screw eyes (to attach the fall prevention cord) (x2)
Note:
•
Use commercially available screws that are capable of supporting over 30 k
g
.
•
Use a cord that is capable of supporting over 30 k
g
(with a diameter of about 1.5 mm).
1
Attach the cord to the main unit.
If the cord cannot be threaded through the holes, try bending the cord, about 5 mm apart from the tip,
at an angle of 45° (as illustrated above).
2
Place the main unit in the desired position and attach each cord onto the
rack or table.
Make sure that the slack of the cord is minimal.
Do not lean the main unit against the TV or wall.
Attach the screw eye at a position capable of supporting over 30 k
g
.
Depending on the placement of the main unit, the screwing position of the screw eye may differ.
Cord
Cord
Screw eye
