Operating Instructions
CD Stereo System
Model No.
SC-EN27
SC-EN26
SC-EN25
System
SC-EN25
SC-EN26
SC-EN27
Main unit
SA-EN25
SA-EN26
SA-EN27
Speakers
SB-EN25
SB-EN26
SB-EN25
SC-EN27 is used in
the illustrations unless otherwise mentioned.
These instructions are applicable to the following systems.
Dear Customer
Thank you for purchasing this product.
Before connecting, operating or adjusting this product, please read the
instructions completely.
Please keep this manual for future reference.
Troubleshooting guide
Before requesting service, make the following checks. If you are in doubt about any of the check points, or if the solutions indicated in the chart do not solve the problem,
refer to the “Customer Services Directory” on page 8 if you reside in the U.S.A., or refer to the “Limited Warranty” on page 8 if you reside in Canada.
No play.
• The disc isn’t correctly set.
• The disc is scratched or dirty. (Tracks skipped.)
• There is moisture on the lens. Wait for about an
hour and then try again.
MP3 cannot be read.
(SC-EN27)
• You may not be able to play MP3 if you have copied
a multi-session disc that has no data between
sessions.
• When creating a multi session disc, it is necessary
to close the session.
• The amount of data on the disc is too small. Set the
amount of data to greater than approximately 5 MB.
Sound is un
fi
xed,
reversed or comes
from one speaker only.
• Check the speaker connections. (
page 2)
No sound or there is a
lot of noise.
• Noise may occur when playing MP3 if recording
quality is poor.(SC-EN27)
• Keep this unit away from mobile telephones.
• Turn the volume up.
• Switch the unit off, determine and correct the cause,
then switch the unit on. Causes include shorting of
the positive and negative speaker wires, straining of
the speakers through excessive volume or power,
and using the unit in a hot environment.
Humming heard during
play.
• An AC power supply cord or
fl
uorescent light is near
the cords. Keep other appliances and cords away
from this unit’s cords.
This product may receive radio interference caused by mobile telephones during
use.
If such interference is apparent, please increase separation between the
product and the mobile telephone.
A beat sound is heard
while receiving a radio
broadcast.
• Switch the TV off or separate it from the unit.
A low hum or noise is
heard during AM
broadcasts.
• Keep the antenna away from other cables and
cords.
• Keep the AM antenna away from the unit.
The picture on the
television near the set
disappears or stripes
appear on the screen.
• The location and orientation of the antenna are
incorrect.
• The TV antenna wire is too close to the unit.
Separate the antenna wire of the TV set from the
unit.
Remote control
doesn’t work.
• Check that the batteries are inserted correctly. (
page 2)
• Replace the batteries if they are worn.
Display
– –:– –
• You plugged the AC power supply cord in for the
fi
rst
time or there was a power failure recently. Set the
time. (
page 5)
• The total programmed play time is more than 200
minutes.
Tracks can still be programmed and played.
FULL
• The number of programmed tracks is limited to 24.
No further tracks can be programmed.
NO/MP3
• A CD-ROM disc that is not CD-DA or MP3 format is
inserted.
It cannot be played.
ERROR
• Incorrect operation performed. Read the instructions
and try again.
F76
• There is a power supply problem. Consult the
dealer.
Panasonic Consumer Electronics
Company, Division of Panasonic
Corporation of North America
One Panasonic Way Secaucus,
New Jersey 07094
http://www.panasonic.com
Panasonic Puerto Rico, Inc.
Ave. 65 de Infantería, Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985
Panasonic Canada Inc.
5770 Ambler Drive
Mississauga, Ontario
L4W 2T3
www.panasonic.ca
© 2005 Matsushita Electric Industrial Co., Ltd.
Printed in China
RQT8520-P
M1205KS0
P
PC En
SC-EN25 26 27PPC̲4.indd 1
SC-EN25 26 27PPC̲4.indd 1
2005-12-12 18:05:42
2005-12-12 18:05:42
