Reference
Optional speaker
settings
45
VQT3M52
1
Attach the cushion foot (supplied) (
A
) on
the bottom of the speaker.
≥
If you repeat attaching and removing the cushion foot,
degree of tackiness weakens.
2
Place the speakers facing the inclined
surface (
B
) toward outside.
∫
To attach speaker stand again
1
Put the speaker cable through the speaker stand.
A
: top of the stand
≥
Make sure to match the direction of the speaker
connector and the hole (
B
) on the stand.
2
Secure the cable with the speaker (
C
), and put the
speaker and the stand together pulling the cable as
illustrated (
D
).
3
Attach the stand referring to the detaching operation 1 and
2 (
>
44).
≥
Fix the speaker and the stand with the screws and the
bracket, and then secure the speaker cable into the
groove.
Reference
Troubleshooting guide
Before requesting service, please perform the
following checks.
If the problem remains unresolved, consult
your dealer for instructions.
The following do not indicate a problem with this unit:
j
Regular disc rotating sounds.
j
Image disturbance during search.
– Image disturbance when replacing 3D discs.
∫
Unit doesn’t respond to remote control
or front panel buttons.
Press and hold [
Í
/I] on the main unit for 5 seconds.
j
If still unable to turn the unit off, disconnect the AC mains
lead, wait 1 minute, then reconnect the AC mains lead.
∫
Cannot eject disc.
The unit may have a problem.
While the unit is off, press and hold [
9
] on the remote
control and [
<
OPEN/CLOSE] on the unit at the same time for
more than 5 seconds.
To return to the factory preset.
≥
Select “Yes” in “Default Settings” in the Setup menu. (
>
43)
To return all settings to the factory preset.
≥
Reset the unit as follows:
While the unit is off, press and hold [+ VOLUME], [
<
OPEN/
CLOSE] and [
Í
/I] on the main unit at the same time for more
than 5 seconds.
The remote control doesn’t work properly.
≥
Change the batteries in the remote control. (
>
7)
≥
The remote control and main unit are using different codes. If
“SET
” is displayed on the unit’s display when a button is
pressed on the remote control, change the code on the
remote control. (
>
43)
Disc cannot be played.
≥
The disc is dirty. (
>
7)
≥
Check the region code.
Still pictures (JPEG) do not playback normally.
≥
The images that were edited on the PC, such as Progressive
JPEG, etc., may not playback.
The TV tuner mode is not displayed when the TV is
switched on.
≥
This phenomenon may occur, depending on the TV setting,
when “Quick Start” is set to “On”.
≥
Depending on the TV, this phenomenon may be prevented
by reconnecting the HDMI cable to a different HDMI input
terminal or by changing the HDMI auto connection setting.
Positioning speakers
horizontally
[BTT262]
C
B
A
D
Do you have the latest firmware installed?
Firmware updates may be released to correct operating
irregularities that are discovered with certain movies. (
>
22)
General operation
VQT3M52~Body_mst.fm 45 ページ ２０１１年１月２６日 水曜日 午前１０時２分
