44
VQT3M52
Optional speaker settings
Speaker installation
option
You can attach all of the speakers (except subwoofer) to a wall.
≥
The wall or pillar on which the speakers are to be attached
should be capable of supporting 10 k
g
per screw. Consult a
qualified building contractor when attaching the speakers to
a wall. Improper attachment may result in damage to the wall
and speakers.
≥
Do not attempt to attach these speakers to walls using
methods other than those described in this manual.
[BTT262]
Preparation
≥
Remove the speaker stands.
1 Remove the screws and the bracket (
A
) from the
speaker.
2 Detach the speaker stand.
≥
Remove the speaker cable from the groove (
B
).
≥
Pull out the speaker cable from the stand, making sure
to match the direction of the speaker connector and the
hole on the stand.
≥
Keep the removed stands, screws and brackets for future use.
1
Drive a screw (not supplied) into the wall.
A
At least 30 mm
B
‰
4.0 mm
C
‰
7.0 mm to
‰
9.4 mm
D
Wall or pillar
E
5.5 mm to 7.5 mm
2
Fit the speaker securely onto the screw(s)
with the hole(s).
Use the measurements indicated below to identify the
screwing positions on the wall.
≥
Leave at least 20 mm of space above the speaker and 10 mm
on each side to allow enough space for fitting the speaker.
Front speaker
≥
[BTT362]
Attach to a wall without the base.
F
40 mm
G
63 mm
H
322 mm
I
37 mm
J
45 mm
K
190 mm
∫
To avoid speaker dropping
≥
Consult a qualified building contractor to avoid damage to
the wall or speakers.
≥
Use a string of less than
‰
2.0 mm, which is capable of
supporting over 10 k
g
.
Attaching to a wall
1
2
e.g.,
[BTT362]
Front speaker
DO NOT
DO
≥
In this position, the
speaker will likely fall if
moved to the left or right.
≥
Move the speaker so that
the screw is in this
position.
[BTT362]
[BTT262]
A
String (not supplied)
B
Screw eye (not supplied)
C
Less than 10 cm
D
Rear of the speaker
SCBTT362_262_EB_VQT3M52_eng.book 44 ページ ２０１１年１月２５日 火曜日 午後８時２２分
