Panasonic RX-D26, Руководство по эксплуатации, Страница: 3 / 8

RQTT0622
3
The radio
Normal tuning
1 Press [TUNER/BAND] to select “FM” or “AM”.
(Unit comes on.)
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
2 If “ ” is on the display, press
[TUNE MODE] to clear it.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
3 Press [– / ] or [ / +] to tune
to the desired station.
Automatic tuning
Press and hold [– / ] or [ / +] then release when the frequency
display starts to change. A station with good reception is automati-
cally selected and the process stops.
To stop automatic tuning, press [– /
] or [ / +] again.
Note
Automatic tuning may stop on a frequency where there is no station
if there is interference. Press [– /
] and [ / +] to tune if this
occurs.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4
Adjust the volume.
To improve reception
FM: Extend the whip antenna and adjust its direction.
AM: Adjust the position of the unit.
If noise is excessive in the FM stereo mode
Press [FM MODE]. (“MONO” lights up.)
Sound will be produced in monaural, but this
also reduces noise.
Press the button again to cancel. (“MONO”
goes out.)
For area except for United Kingdom and Continental Europe
AM allocation setting
Before receiving AM broadcasts, be sure to select the correct allocation
setting (either 9 kHz or 10 kHz) for your area.
First press [TUNER/BAND] to select AM. Next, press and hold
[ / CLEAR]. The display changes in a few seconds to show the current
lowest AM frequency. Continue to hold down the button.
When the minimum frequency changes, release the button.
Changing the step erases all preset stations.
Repeat the above to change the step back.
1 2 3 4
Preset tuning
1 2 3
1 · 2 · 4
3
Preset the stations (20 FM and 12 AM) to make tuning simpler.
Automatic presetting
Do the following once each for FM and AM.
Preparations: Press [TUNER/BAND] to select “FM” or “AM”.
Press and hold [–AUTO PRESET] until “AUTO” is displayed.
The tuner presets stations it can receive into the channels.
Presets one station at a time.
Preparations: Tune to the desired station.
(Perform steps 1-3 on the left.)
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
1
Press and hold [–PGM].
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
2
While “ ” and the frequency display
are flashing
Press [–PGM].
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
3
While “ ” and the preset channel are
flashing
Press [–/ ] or [ /+] to select
the desired channel.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
4 Press [–PGM].
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Repeat the above to preset other stations.
The station occupying a channel is erased if another station is preset in
that channel.
Manual Presetting
Press [TUNER/BAND] to select “FM” or “AM”.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Press [TUNE MODE] to display
“
”.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Press [– / ] or [ / +] to
select the desired channel.
(FM:1-20, AM:1-12)
Preset channel
1
2
3
To listen to preset channels
Preset channel
RX-D26̲1B-2-3 04.1.29, 14:16 Page 3 Adobe PageMaker 6.5J/PPC