Panasonic PV-500, Руководство пользователя

Страница: 407 / 494

405
C
o
nt
rol
w
it
h C
om
m
uni
c
a
tion P
or
t
C
h
ap
te
r 9
INDE
X
Print Screen
It is output into the place specified from “ENVIRONMENT” -> “Input/Output” -> “Print Screen” -> “Destination”.
This command cannot specify the destination.
Send % P S BCC CR BCC = 26 or **
Receive
% P S $ BCC(02) CR
Error (ERROR 1 signal = ON)
% P S ! Error code (3-digit) BCC CR
Error code
200 Operation is stopped
265
• No SD memory card is attached or cannot be accessed.
• Capacity of the SD memory card is used up.
• The SD memory card is write-protected.
• Ethernet communication cannot be established (with connection problems
such as cable unconnected or disconnection)
• Image Receiver is not activated or stopped.
Resetting Statistics Data
Resets statistics data and scan count.
Send % Q BCC CR
BCC = 74 or **
Receive % Q $ BCC(50) CR
Error (ERROR 1 signal = ON)
% Q ! Error code (3-digit) BCC CR
Error code
200 Operation is stopped
Switch between Run/Stop
Send
% R M ? BCC CR ? = 0 - 1 (0 = switch to RUN, 1 = switch to STOP)
Receive % R M $ ? BCC CR
? = 0 – 1 (0 = RUN, 1 = STOP)
Error (ERROR 1 signal = ON)
% R M ! Error code (3-digit) BCC CR
Error code
240
• Specification of the parameter is wrong. (A number other than 0 and 1 was
specified.)
• PV500 sent a command in the following inoperable state.
- When selecting "TOOL" > "General", "Setting Help" or
"Update”
- When displaying SETUP menu when "Run Mode in SETUP
Menu" is set to "Not Available”
Example: Switches to Run.
Send % R M 0 * * CR
Receive % R M $ 0 2 E CR