Panasonic PV-500, Руководство пользователя

Страница: 334 / 494

332
E
n
v
iro
n
m
e
n
t S
e
tt
in
g
s
C
h
ap
te
r 6
Selecting a Type to Be Read at Startup
Select a type to read at startup.
Also from the type switching window, the setting of a type to read at startup can be changed. Refer to page 56
for details.
1
. Select "Setup Setting" in “System Settings” setting window.
2
. Select “Type No.”
Last Type No. (default): Reads again the type selected right before turning off the power. The
setting is done if you select this.
Selected Type No.:
Reads the type No. specified after.
3
. Specify a type No. to read in “Select Type No.”.
4
. After setting is completed, press the CANCEL key.
The last type No. is held by using the backup battery on the back of PV500. When the battery runs out
or no battery is installed, the type with the smallest number from the existing types is called up. Also, if
the type specified in "Select Type No." does not exist at startup, the type with the smallest number
from the existing types is called up.
6.2.2 Selecting Operation when Switching to SETUP Menu
(Operation/Password)
About Inspection Continuance
You can select whether you continue the inspection when switching to SETUP menu during an inspection in
RUN menu. As the default setting, it is set to stop the inspection when switching to SETUP menu.
If you switched to SETUP menu from RUN menu during an inspection stoppage, the operation remains
stopped regardless of this setting.
1
. Select "Operation" in “System Settings”
setting window.
2
. Select “Not Available” or “Available” for "RUN
Mode in SETUP Menu ".
Not Available (default): Stops the operation when
switching to SETUP menu.
Available: Continues the operation even when
switching to SETUP menu.
To stop operation in SETUP menu, select
"OPERATION” > “Stop RUN Mode” from the menu
bar.
To restart operation, select "OPERATION” > “Start
RUN Mode”.