Panasonic PV-500, Руководство пользователя

Страница: 209 / 494

207
Se
tt
ing I
n
s
p
e
c
tio
n C
on
d
it
ions
C
h
ap
te
r 4
INDE
X
4.8.4 Applying Position Adjustment to Checkers
Which Position Adjustment is applied to checkers must be determined because multiple Position Adjustments
can be registered for a Type. To do so, select a Position Adjustment in Area Setting window of each checker.
An area of Position Adjustment checkers also can be adjusted by Position Adjustment. The procedure below
uses Position Adjustment checker to describe, however, the procedure for other checkers is the same.
1.
Select a target checker.
(In this example, Position Adjustment
(Gray Edge))
2.
Select "Checker Settings".
When target checker is other than position
adjustment, select “Set” of “Area Setting”.
3.
Select "Position Adjustment".
The list of Position Adjustments that have
been set is displayed.
As selecting a number with the cursor, the
Position Adjustment area of the number is
displayed in orange on the screen window.
Observe it to select.
4.
Select a Position Adjustment No. to refer
the adjustment amount.
The selected type No. is displayed in the
“Position Adjustment” field.
To cancel applying a position adjustment,
select “No” in the top of the list.
* About selectable position adjustment
When target checker is Position Adjustment
The number of Position Adjustment checkers must be lower than the number of the currently setting Position
Adjustment.
If the currently setting Position Adjustment is No.9 with camera No.0, only the set Position Adjustment checkers
of No.0 to 8 with camera setting of No. 0 and 1 are displayed.
Position Adjustment and checkers with different camera number setting
When more than one camera is used, the Position Adjustment with camera setting of No,0 or 1 cannot adjust
the checkers with camera setting of No.2 and 3, and vice versa.
Position Adjustments unselectable for adjusting checkers are not displayed in Step 3 above.
Camera No. of Position Adjustment available to adjust
0 1 2 3
Camera No. of
adjusted checker 0 Yes Yes No No
1 Yes Yes No No
2 No No
Yes Yes
3 No No Yes Yes
Yes: Selectable, No: Not selectable