Panasonic Panafax UF-8100, Руководство по обслуживанию

Страница: 73 / 374

73
UF-7000/8000
APR 2007 Ver. 2.1
UF-7100/8100
3.5. Updating the Firmware
The Quick and Easy Methods of Updating the Firmware are to use the Network Firmware Program
Tool (FUP) using Ethernet LAN Port and a Crossover Cable or to use a Master SD Memory Card.
The Network FUP Tool version must be 3.XX or higher, and it can be found on the Panasonic Document
Management System CD-ROM included with the main unit or on the CD-ROM included with the PCL
option.
Refer to the Firmware Update Operation Instructions, Service Notes (8.1.) for additional details.
3.5.1. Firmware Configuration
A. Hardware Configuration
This machine is controlled by a Main CPU which is located on the System Control (SC) PC Board and
other sub CPUs on the PCBs. The Firmware of SC PCB and 2nd G3 PCB can be updated using a PC
or an SD Memory Card.
B. SC PC Board Firmware
The 4 MB Program Memory (F-ROM) is integrated on the SC PCB. An Optional Expansion 8 MB
Program Memory (FRM8 PCB) can be installed into SLOT 1.
The Firmware to be written into the 4 MB onboard and the 8 MB of SLOT 1 depends upon Standard or
PCL Option.
(1) Standard
The Standard Program (1) is only written into the 4 MB onboard, which is assigned as ROM
Code (A).
(2) For PCL Option
The PCL Control Program (2) must be written into the 4 MB onboard, which is assigned as ROM
Code (B). The PCL Control Program (3) and PCL Font data (4) are written into the 8 MB in the
SC PC Board
Standard
Configuration
With PCL Option
Configuration
On Board (A)
4 MB
(B)
4 MB
PC
(1) (2)
CPU
4 MB
Program Program
Ethernet Port
F-ROM
PC
USB Port
Slot 1 (CN515)
(C)8MB
8 MB
FRM8 PCB
SD Memory Card
(32 MB up to 512 MB)
Panel Control Program
2nd G3 PC Board
CPU
4 MB
Scanner Control Program
F-ROM
CPU
CPU
Panel PC Board
SDR PC Board
Printer Control Program
CPU
Printer Engine PC Board
SD Memory Card Port
(3)
Program
4 MB
(4)
Font
4 MB