137
P
roblem S
o
lving
Problem Solving
Verification Stamp
Verification Stamp
The Verification Stamp contains ink. When the stamp mark appears faded or hard to see, the stamp should be replaced or
refilled with ink.
To remove the stamp
NOTE
1. Please contact your local Authorized Panasonic Dealer to purchase a new stamp.
2. Stamp ink refills can be purchased from a stationary store. Use blue Shachihata "X" Stamp ink
(No. 22113) or its equivalent.
Open the ADF Cover
Remove the Stamp. Replace the stamp with a
new one or refill the stamp with a few drops of
the specified ink into the back of the stamp.
(see Note 1)
Verification Stamp Order No.: DZHT000027
1
2
Close the ADF Cover.
3
Replacing the Battery
REPLACE BATTERY
U90
Battery Holder
1
2
Battery Holder
3
: Turn the Power Switch on the
Back Side of the machine to
the OFF position.
: Remove a Screw and the
Bettery Holder
1
2
"+" side of battery should be
facing upwards.
(Observe the polarity, see
CAUTION! below)
: Reinstall the Battery Holder
and fasten the Screw.
: Turn the Power Switch on
the Back Side of the
machine to the ON position.
1
2
4
If the clock is flashing on the LCD Display, follow the
procedures on page 106 to reset the clock.
Keep button battery/verification stamp and small parts out of reach of children to prevent
chocking or poisoning. If a button battery/verification stamp is swallowed accidentally, get
medical treatment immediately.
NOTE:
The service life of the battery is approximately 1
year under normal use.
denotes hazards that could result in minor injury or damage to the machine.
THIS PRODUCT CONTAINS A LITHIUM BATTERY. REPLACE ONLY WITH THE SAME OR
EQUIVALENT TYPE. "IMPROPER USE OR REPLACEMENT MAY CAUSE OVERHEATING,
RUPTURE OR EXPLOSION RESULTING IN INJURY OR FIRE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS OF YOUR LOCAL SOLID WASTE
OFFICIALS AND LOCAL REGULATION"
CAUTION
!
CAUTION
!
4
The machine has an internal battery (Product No.: CR2032) which
maintains the date and time.
In the event the battery requires replacement, a message will be displayed.