Panasonic Over The Range Microwave Oven, Инструкция по установке

Страница: 1 / 8

Panasonic Over The Range Microwave Oven
INSTALLATION INSTRUCTIONS
Page 1
Read carefully and keep these installation instructions
A REQUIREMENTS FOR INSTALLATION
Installation of this product is safest and easiest when performed by two people. Before beginning the
installation, please read the following requirements to make sure you have everything you need to safely
install this product.
1. SUPPLY CIRCUIT AND GROUNDING REQUIREMENTS
This oven must be plugged into at least a 15 AMP, 120 volt, 60 Hz, 3 prong grounded outlet. The outlet
must be connected to at least a separate 15 AMP circuit of the proper voltage and frequency. No other
appliance should share the circuit. Wire size must conform to the requirements of the National Electric Code
or the prevailing local code for this kilowatt rating.
The recommended location for this outlet is inside the cabinet directly above where the oven is going to be
installed. This location is desirable because the power supply cord on the product is short. If an outlet is not
readily available, one should be installed by a qualified electrician and should conform to the National
Electric Code or the prevailing local code.
The installer must perform a ground continuity check on the outlet box to ensure that it is properly grounded,
and if it does not meet the electrical requirements of the product a qualified electrician should be employed
to correct any deficiencies.
2. MOUNTING SURFACE WEIGHT CAPACITY REQUIREMENTS
FOR PERSONAL SAFETY, ANY MOUNTING SURFACE FOR THIS PRODUCT MUST BE CAPABLE OF
SUPPORTING THE PRODUCT'S WEIGHT OF 55 lbs. (25 kg). PLUS ADDITIONAL OVEN LOADS OF UP
TO 22 lbs. (10 kg). FOR A TOTAL WEIGHT OF 77 lbs. (35 kg).
Proper installation of this product requires that the product be partially supported by the bottom surface of
the cabinet directly above the mounting location. Therefore reinforcing this bottom might be necessary if the
cabinet cannot support the weight requirement mentioned above.
4. EXHAUST REQUIREMENTS
This product is shipped for use in the top exhaust ventilation mode
.
If you wish to install this product without using an exhaust duct, the exhaust must be recirculated through the
front grille and the charcoal filter. This product is shipped with a standard charcoal filter already installed.
The Charcoal Filter cannot be cleaned and should be replaced periodically every 6 to 12 months, or more
often if necessary.
When necessary to replace the charcoal filter, it can be purchased from your local Panasonic dealer.
The part number of the replacement charcoal filter is NN-CF203, refer to the following instructions for
replacement.
5. TOOL REQUIREMENTS
*Electric or hand drill with
3
/
16
", and
3
/
8
" bits.
*Marking pen
*Electric or hand jigsaw
*Side cutter or tin snipper
*Phillips screwdriver
*Tape measure
*Adhesive tape
*Metal file
3. MOUNTING SPACE REQUIREMENT
A minimum width of 30" (76 cm) is required on a flat,
vertical wall for installation of this product.
The top surface of the product must be a minimum
of 68
3
/
8
" (179.5 cm) above the floor and a minimum
of 32
3
/
8
" (82 cm) above the cooking surface.
This product is suitable for use above gas or electric
cooking equipment 36 in. or less. To reduce the risk
of fire or electric shock. Install at least 16" (40.6 cm)
above any cooktop. (Fig. A-1)
30"
(76 cm)
Fig. A-1
16"
(40.6 cm)
MINIMUM
68
3
/
8
"
(179.5 cm)
MINIMUM
32
3
/
8
"
(82 cm)
MINIMUM