Panasonic OmniVision PV-M1347, Руководство по обслуживанию

Страница: 33 / 143

2-15
Center Clutch Unit, Changing Gear Spring,
Changing Gear, Changing Lever-B, and Idler
Arm Unit
Disassembly Procedure
1. Remove Cut Washer (B). Then remove the Center Clutch
Unit, Changing Gear Spring, and Changing Gear.
2. Remove Changing Lever -B while releasing 2 Locking Tabs
(K).
3. Pull up on the Idler Arm Unit.
FIg. J14-1
Reassembly Notes
1. Installation of Center Clutch Unit
1) Fit the Center Clutch Unit into the Changing Gear as
shown.
Fig. J14-2
2. Cut Washer (B) is not reusable. If removed, install a new
one.
32 Center
Clutch Unit
35 Changing
Lever -B
Locking
Tabs (K)
33 Changing Gear
Spring
Cut Washer (B)
34 Changing Gear
36 Idler Arm Unit
Center Clutch Unit
Changing Gear
Locking Tab (J)
30 T Loading Arm Unit
31 S Loading
Arm Unit
Loading Rack
Through Hole
Loading Rack
Triangle Indent
T Loading Arm Unit S Loading Arm Unit
Arrow
Through Hole
T Loading Arm Unit and S Loading Arm Unit
Disassembly Procedure
1. Remove the T Loading Arm Unit by pulling it up while
releasing Locking Tab (J).
2. Pull up on the S Loading Arm Unit.
Fig. J13-1
Reassembly Notes
1. Alignment of T Loading Arm Unit and S Loading Arm
Unit
1) Slide the Loading Rack so that the holes on it and the
holes on chassis line up properly.
2) Install the S Loading Arm Unit onto the Chassis.
3) Install the T Loading Arm Unit so that the triangle-
shaped indent is aligned with the arrow on the S
Loading Arm Unit as shown. Confirm that each of holes
on the T Loading Arm Unit, Chassis, and the Loading
Rack are through holes.
Fig. J13-2