- 17 -
IMPORTANT
1. Disconnect or unplug all units from the wall socket
before attempting to stack.
2. For stacking installation, you must use the
PANASONIC Joining Plate which is enclosed with
this unit.
3. The following PANASONIC models only are suitable
for stacking:
NE-1057, NE-1457, NE-1247, NE-1747, NE-1047,
NE-1447, NE-1257, NE-1757, NE-1442, NE-1856,
NE-1456, NE-1846, NE-1446, NE-2156, NE-2146,
NE-1856-2
4. The maximum stacking height is the total heights of
two units.
PREPARATION
Be sure the oven cavity is empty.
INSTALLATION
1. Stack the units and remove five screws (a) as shown in Fig.1.
2. Loosen the screw (b).
3. Projection on Joint Plate must face away from the oven. Place Joining Plate on the screw (b).
4. Attach and tighten five screws (a) and the screw (b). See Fig.2.
5. Ensure the top oven is at a safe and workable height.
This oven monitors its operation and displays a Failure Code in Digital Display Window when a problem occurs.
What to do when a Failure Code appears:
Disconnect the oven from the electricity supply and wait more than
ten seconds before reconnecting. If normal operation does not resume, follow the next chart.
CODE
F01
F33-34
F05
F81-82
F86-87
F44
PROBLEM
Too high temperature of
exhausted air
Defective thermistor circuit
Defective memory IC
Defective relay circuit
Defective relay circuit
Defective control panel
WHAT TO DO
The oven shuts off automatically. Disconnect the appliance from the electricity
supply. The oven beeps continuously and resets for operation when cool. Move
the oven to a cooler location. If the problem persists, call service agent.
The oven shuts off automatically. If the problem persists, call service agent.
If the problem persists, call service agent. The oven will operate even if Failure
Code appears, just not as designed. If the problem occurs during memory
heating, press Stop/Reset pad. Then other memory program and manual heating
will be possible.
If the problem persists, call service agent. The oven will operate even if Failure
Code appears, just not as designed. Press Stop/Reset pad and try again.
The oven shuts off automatically. If the problem persists, call service agent.
The oven shuts off automatically. If the problem persists, call service agent.
Note
: Above codes shown in Digital Display Window do not indicate all possible failures on the unit.
(b)
Joining Plate
Projection
(a)
Fig. 1
Joining Plate
Projection
Fig. 2
Installation Instructions for Stacking
Self Diagnostics Failure Code Explanation
